How to Make Your Own Lace Front Wig & Look Natural?
Because of the versatility and believability, Lace front wigs are the most popular trends in hair market.It helps you to pull the wig away from the face and allow you to maintain a variety of hairstyles.
But it works only when you apply it properly. Using a lace front is easy and fast If you follow the right steps of lace front wigs Installation. Once your wig is correctly installed, you can apply any hairstyle on it.
Well, look no further as we give you step-by-step instructions on how to install your lace frontal hair for a fabulous new look that will leave people thinking. I heard a famous company named ”slove rosa “ who teach and help people to do those for women they have many kinds of wig, high quality and good price, short wig and long wig ,brazilian and Peruvian Malaysian ,if you are interested with this store you can click this link: (https://sloverosashop.aliexpress.com/store/329159)
Part one : Getting Ready for the Wig
Do a skin test. Some people are allergic to the chemicals used to keep a wig in place. Do a skin test to determine whether or not you are allergic. First, dab a small amount of liquid adhesive or double-sided wig tape onto the back of your hand. Next, observe the adhesive for at least twenty four hours.
If the skin becomes red or irritated, purchase a hypoallergenic wig tape or adhesive to use instead.
If the skin is unaffected, you can safely wear the wig.
Flatten your hair. The flatter your hair is against your head, the better the wig will look. You can braid short hair into corn rows or mold it against your head using gel and bobby pins.
Put on a stocking cap. Stocking caps, or wig caps, are soft caps that flatten your hair and help the wig stay in place. Gently pull on the stocking cap, being careful not to disturb your flattened hair. Adjust the cap so that it barely covers your hairline. 
If you have little to no hair, skip this step. Otherwise, the cap will slide around your head and bunch up under your wig.
Make sure all of your hairs are tucked into this cap, even the hairs on the nape of your neck.
Prepare your skin. Wash your skin with a gentle cleanser and blot it dry with a towel. Next, dab some rubbing alcohol on cotton ball and wipe it along your hairline. This will remove the excess oils on your skin. If you have sensitive skin, you can apply a scalp-protecting serum after using the rubbing alcohol.
Part two : Putting On the Wig
Test the fit of the wig.Before you apply any adhesives, you need to make sure the wig fits properly. To do so, place the wig on your head and line it up with your natural hairline. If the wig has tightening straps on the inside, you may need to adjust these for a proper fit. If the wig doesn’t fit and it doesn’t have any tightening straps, contact the manufacturer for help.
·If you can feel a strong ring of pressure around your scalp, the wig is too tight. Loosen the straps slightly.
·If the wig slides around when you move your head, the wig is too loose. Tighten the straps.
·Attention: some store selling glueness wig, like we mentioned before: “slove rosa store” on Aliexpress
Trim the lace. Once your wig fits properly, you need to trim the lace. Use a few clips to pull the hair away from your face. Next, using sharp shears, trim the lace along your natural hairline. You should leave about 1/8 inch (3 mm) of lace. This will only have to be done the first time you wear the wig.
Remove the wig and set it aside. Carefully pull the wig off, leaving all the clips in, and set the wig on a clean flat surface. Arrange the wig so that it’s easy to see what part goes on the hairline and what part goes on the nape of the neck.
·If you have to loosen any straps to get the wig off, your wig is too tight.
Use a liquid adhesive. If you don’t want to use wig tape, you can use a liquid lace adhesive instead. Use a clean makeup brush to apply the adhesive in thin line along your entire hairline. Depending on the type of adhesive, you may need to wait a few minutes before wearing your wig.
If you use a soft bond adhesive, allow the glue to dry long enough to become tacky before applying the wig.
If you use a hard bond adhesive, you can apply the wig immediately.
Apply the wig. Carefully pull the wig on. First, adjust the edge of the wig so that the hairlines match. Next, adjust the back of the wig so that it hangs naturally over your hair. Lastly, press the lace of the wig into your adhesive or wig tape.
Once you press the lace into the adhesive or wig tape, it’s very hard to remove. Be sure that the wig is perfectly aligned before doing so.
Style your hair. If your wig is made of human hair,to avoid using regular brushes and hot styling tools. Instead, use a wide-toothed comb or wig brush to adjust your hair.